The California Water Boards' Annual Performance Report - Fiscal Year  2016-17 

MEASUREMENTS  - Data Last Updated on:  03-27-2018 (2:45 pm)

WHAT THE MEASURE IS SHOWING

In Fiscal Year (FY) 2016-17, the Storm Water Program inspected 21 percent of construction facilities statewide with 1,910 inspections performed at 1,629 facilities. For compliance purposes, some facilities are inspected more than once a year, which is why the total number of inspections is greater than the total number of facilities inspected.

WHY THIS MEASURE IS IMPORTANT

Inspections are a primary tool used in determining and documenting compliance with National Pollutant Discharge Elimination System (NPDES) permits and waste discharge requirements (WDR). Inspections are the primary tool used in the NPDES Construction Storm Water Program to assess compliance with NPDES requirements. The Construction Storm Water Program is unique in that some industrial activities (e.g., construction or land disturbance) is temporary in nature. Other industrial activities tend to be more long-term (e.g., cement manufacturing and auto dismantling). As a result, it is critical that inspections of construction facilities occur during actual construction activity. Most construction sites follow a process of (1) grading and land development phase, (2) streets and utilities phase, (3) vertical construction phase, and (4) post construction phase. The type of storm water controls vary depending on the phase of construction. It is also helpful to inspect a construction site during both wet and dry weather periods to determine permit compliance. For all of these reasons, the Storm Water program considers inspection of construction facilities a high priority.

TECHNICAL CONSIDERATIONS

• Data Source: SMARTS. Period July 1, 2015 to June 30, 2016.
• Unit of Measure: Number of facilities inspected at least once during FY 15-16.
• Data Definitions: Inspections: include inspections conducted by Regional or State Water Board staff, or US EPA. It includes any inspection type. Facilities: Include any construction facility enrolled under the storm water construction program that was active at least one day during FY 15-16.
• References: Information on the Water Boards� NPDES Stormwater program
  Public Reports and Data
  Enforcement and Compliance Assurance Information

GLOSSARY

Construction Storm Water Program

Dischargers whose projects disturb 1 or more acres of soil or are part of a larger common plan of development that in total disturbs 1 or more acres, are required to obtain coverage under the General Permit for Discharges of Storm Water Associated with Construction Activity (Construction General Permit, 2009-0009-DWQ).

General Permit

An NPDES permit issued under 40 CFR 122.28 that authorizes a category of discharges under the Clean Water Act (CWA) within a geographical area. A general permit is not specifically tailored for an individual discharger.

National Pollutant Discharge Elimination System (NPDES)

The NPDES permit program (CWA Section 402) controls water pollution by regulating point sources that discharge pollutants into waters of the United States. Point sources are discrete conveyances such as pipes or man-made ditches. Individual homes that are connected to a municipal system, use a septic system, or do not have a surface discharge do not need an NPDES permit; however, industrial, municipal, and other facilities must obtain permits if their discharges go directly to surface waters. US EPA has approved the Water Board's program to issue NPDES permits.

Inspection (Compliance and Non Compliance)

The Regional Board or State Board may inspect the facilities of any discharger at any time pursuant to Water Code, Section 13267. Compliance activities include all activities necessary to determine if discharges are in compliance with waste discharge requirements, NPDES permits, and related enforcement orders. Compliance inspections are classified as either Level A or Level B, with Level A being more thorough.

( Page last updated:  11/1/17 )